Knowledgebase
Configuring Outlook
Posted by Daryl K on 22 January 2013 05:32 PM

MS Outlook Express Setup

1. Click on the tools menu then accounts

2. Click Add on the right side at the top and select mail

3. Display Name: Your Name

4. Click Next

5. E-mail Address: [email protected]

6. Click Next

7. My incoming mail server is a POP3 server.

8. Incoming mail server (POP3): yourdomain.com

9. Outgoing mail server (SMTP): yourdomain.com

10. Click Next

11. Acount Name: [email protected]; If you are setting up for your Main Account you would use your hosting account username.

12. Password: This will be the password you set for the email address when you set it up in your hosting account control panel. If you are setting up for your Main Account, this will be your hosting account password.

13. Check Remember password if you don't want to enter your password each time.

14. DO NOT CHECK \"Log on using Secure Password Authentication (SPA)\"

15. Click Next then Finish

16. Click on the account you just created then click Properties

17. Click the Servers tab

18. CHECK \"My server requires authentication\" at the bottom

19. Click the Advanced tab

20. Under Server Port Numbers Incoming server (POP3): 110

21. Under Server Port Numbers Outgoing server (SMTP): 25; If you ISP blocks access to port 25 you can use port 9925 or 465 (if using secure SSL for SMTP)

22. Click OK to close that window.

23. Click Close to close that window.

(0 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
Help Desk Software by Kayako Fusion